USER MANUAL
9
Figure 9
Solution tank filling
CAUTION
！
！！
！
Only low foam, nonflammable detergents may be used. These detergents must be
suitable for the use of scrubbers.
9. Open the
water inlet cover (27) and add water to solution tank. Do not overfill the tank. When
preparing the cleaning solutions, please follow the dilution rates supplied by the chemical
manufacturer Water temperature must not exceed 40
0
C.
REGULATING WATER FLOW
WARNING
！
！！
！
Regulating the ball valve handle (A, Figure 10) must be
done under the condition when the power switch (41)
is in the “Off” position.
10. The volume of the water flow may be adjusted through the ball
valve handle (A, Figure 10) according to the amount of water
required for your scrubbing application.
MACHINE START AND STOP
Starting the machine
1. Complete the preparatory steps as outlined above.
2. Press the power switch (41) to the “I” position.
3. Use the squeegee handle (41) to lower the squeegee.
4. Press the Vacuum switch (42) to the “I” position.
5. Press the solution switch (44) to the “I” position. (Work
simultaneously with the safety switch (1) to control the
solenoid valve.)
6. Squeeze the on / off switch (1) and push to move the
machine. When switches are squeezed, the brush (29) will
to rotate, and the solution will flow.
CONSULTATION
：
：：
：
Each safety switch is capable of controlling
independently the operation of the brush. In use,
it facilitates the control of the operation of the
machine.
Operators are encouraged to find the most
comfortable position their hands.
Figure 11
Figure 10
To Next Page
Loading...
Need help?
General
