Selecting and regulating the voices (Voicing menu)
After Orchestra sounds are programmed it is possible to store them in the desired combination. If you wish to set
a different Orchestra sound in a different combination but associate it to the same register, enter the edit menu,
select the voice, adjust the parameters as required and save all the settings in another combination.
Keep in mind that once a different orchestral sound is selected, it will be associated to that stop also when future
combinations are saved, even if the stop is saved as “off”.
If the orchestral sound has been changed and/or its parameters have been
modified and these changes have been saved in a combination, when the
combination is recalled and the register is turned on, the name of the orchestral
voice is displayed between two asterisks to highlight that the stop no longer recalls
the voice expected from the Pipe Set.
After an Orchestra stop has been set by recalling a combination, it is still possible to immediately restore the voice
and parameters of the current Pipe Set by keeping pressed for a few moments the thumb piston in the position of
voice OFF while the main video page is displayed and when the voice is on.
The changes applied to the Orchestra sounds with this procedure are not applied to Orchestra voices
used by the current Pipe Set and their settings. Selecting another Pipe Set or displaying the video pages
of the VOICING menu, will set the Orchestra registers as prescribed by the Pipe Set and not by the
While adjusting the VOICING parameters, in order to assign a voice to a stop and to adjust it, we advice
to select the desired voice first and then to adjust its generation parameters. Please do so, as when a
new voice is selected, its parameters are reset to default values.
-
To save the same orchestral voice and its parameters equal to those of the Pipe Set in the combination,
you must enter the edit orchestra screen at least once, otherwise the instrument will save in the
combination only the On/Off status of the stop and not the desired orchestral voice and its parameters.
Saving a memory without viewing the orchestra edit screen saves the On/Off status of the stops, but not
the voice and the parameters which therefore will always be those of the selected Pipe Set (verifiable on
the main page from the name of the voice displayed without asterisks).
To Next Page
Loading...
