Page 30 Vision Microsystems Incorporated
Oil Pressure Sensor Installation
Use the J3 connector harness 790420 labeled OILP. Mount the two ring
terminals to the two terminals on the sensor using the hardware screws.
Mount the pressure sensor to the pressure line using a 3 to 6-inch flexible
hose and fittings (not supplied) as depicted in the drawing below. Use tie-
wraps or Alon clamp to mount the pressure sensor to firewall. Do not
mount the sensor directly to the engine. Connect the other end of the
hose to the engine manufactures recommended location for oil pressure
on the engine.
Fuel Pressure Sensor Installation
Transducer for carbureted engines:
flexible tube 6 inch (AEROQUIP 303)
AN-910-1D
1/8 NPT coupling
AN-816-4D
1/8 NPT to flared
MIL-H-8794 hose
MS-24587 fitting (AEROQUIP 491, 2 req'd)
to engine fitting
DO NOT MOUNT SENSOR DIRECTLY TO ENGINE
JPI supplied transducer, all other hardware supplied by installer
Connect to P5 connector harness 790719-X
1
FP GND BLK
FP SIG+ WHT
FP PWR RED
FP SIG- GRN
Transducer PN 3018 for injected engines:
To Next Page
Loading...