Visioneer NETSCAN 4000 User Manual

INFORMATION MESSAGES 113
INFORMATION MESSAGES DURING NETWORKING
Message Action
The connection has failed.
Please check network settings.
Ping the IP address of the scanner from another PC in a
DOS prompt. For example, type “Ping 10.1.20.144” in a
DOS prompt. If the scanner has no response, then
perform the following steps.
1. Check if the RJ-45 connector is firmly plugged-in.
2. Check the Ethernet cable.
3. Check the scanner’s IP address.
4. Check the destination IP address.
5. Check Subnet Mask.
6. Check Gateway IP.
The address is invalid.
Please check network settings.
Network is down.
Please check network settings.
Network is unreachable.
Please check network settings.
Connection aborted by the server.
Please check network settings.
Connection reset by the server.
Please check network setting.
Connection timed out.
Please check network setting.
Unable to reach the destination
host.
Please check network settings.
Failed to connect mail server.
Please check network environment.
Check network environment.
Connection error.
Please check network environment.
Failed to create socket for DHCP Check IP address of DHCP server or contact your
network administrator for further help.
Failed to search DHCP server.
Failed to get IP from DHCP server.
Failed to renew IP from DHCP
server.

Visioneer NETSCAN 4000 Specifications

General

Brand	Visioneer
Model	NETSCAN 4000
Category	Scanner
Language	English