VISUAL 100 - Set-Upp Feature Definitions; Copy Mode; Printer Controller Mode; Auto Print Mode

VISUAL TECHNOLOGY INCORPORATED, 540 MAIN STREET.TEWKSBURY, MA 01876
6.2 SET-UPP FEATURE DEFINITIONS
This section details each SET-UPP feature and their effects on the terminal and printer.
6.2.1 Copy Mode
The setting of this feature determines whether or not Copy mode is enabled. Copy mode is
explained in Section 6.3.2.
NOTE
Resetting Copy mode will also reset Printer Controller mode.
6.2.2 Printer Controller Mode
The setting of this feature determines whether or not Printer Controller mode is enabled.
Printer Controller mode is explained in Section 6.3.3.
NOTE
Setting Printer Controller mode will also set Copy mode. Resetting Printer
Controller mode will also reset Copy mode.
6.2.3 Auto Print Mode
The setting of this feature determines whether or not Auto Print mode is enabled. Auto
Print mode is explained in Section 6.3.4.
6.2.4 Underline Sequence
This feature is applicable to the Print Page Command only. When enabled, this feature
causes underlined data on the screen to also be underlined on the printer. This is accom-
plished by sending the data character followed by the backspace character (BS) followed by
the underline character to the printer for every underlined character on the screen.
When this feature is disabled only the characters on the screen will be sent to the printer
when the Print Page function is initiated.
6.2.5 Printer Busy
The setting of this feature depends on how the attached printer indicates a BUSY condition
to the terminal.
If the printer uses a printer busy control line to indicate a BUSY condition, this feature
should be set to "O", the control line state. If the printer uses XON/XOFF to indicate a
BUSY condition, this feature should be set to "1 ",the XON/XOFF state.
NOTE
The Auto XON/XOFF SET-UP feature must be enabled for the terminal to
send XOFF/XON to the host when the printer is busy.
48