Vitec Multimedia MGW Diamond - Page 17

MGW Diamond Multi-Channel HEVC and H.264 Portable Encoder
User Manual, Version 1.6 17
To configure the appliance's network settings for the first time using an SSH client:
1. Open an SSH terminal window (PuTTY is the recommended tool).
2. Connect to the MGW Diamond IP address.
3. At the login prompt, type "user", and at the password prompt type the password (the
default is "1qaz!QAZ").
4. To set up network parameters, type "network" to configure the applicable settings.
5. To display the available commands using SSH, type "help". See the figure below for the
available commands:
Figure 3-5: Help Commands for SSH
NOTE:
The SSH API documentation is available at this location: https://IP_Adress/clidoc.pdf.