MGW Diamond Multi-Channel HEVC and H.264 Portable Encoder
User Manual, Version 1.6 40
Target Section
Enter the channel name. This name will also appear in Session
Announcement Protocol (SAP) messages.
Select the streaming protocol: UDP TS, RTP TS, RTP ES (RTSP),
Zixi™ or Pro-MPEG.
Enter the target IP address.
Enter the TTL value.
• Time-to-live (TTL) tells a network router whether or not the packet
has been in the network too long and should be discarded. Each
time an IP packet hits a router, TTL value is reduced by '1'. If TTL
remains greater than 0, the router forwards the packet. Otherwise,
it is discarded.
• Set a value which is high enough to ensure streaming packets are
reaching the decoder.
• TTL value can be found by pinging the remote decoder.
• Value range is 1-255.
Select the UDP packet size value.
Some transmission link accepts smaller UDP packet size.
Reduce the UDP packet size if experiencing decoding problems.
Select the SAP check box to enable Session Announcement Protocol
(currently not in use).
Select the Traffic Shaping check box to enable network smoothing.
Error Correction
Settings
Available with Zixi™ and Pro-MPEG modes.