OSD Introduction - ALIGNMENT
INPUTPICTURE
Projection Mode
Fan Mode
Lens Control
Lens Memory
Center Lens
Warp
Blanking
Edge Blend
< Front >
< Normal >
Enter
Enter
Execute
Enter
Enter
Enter
LAMPS
ALIGNMENT
CONTROL SERVICE
y Projection Mode
Use function to select the projection mode (Front, Rear, Ceiling + Front, Ceiling + Rear).
y Fan Mode
Use function to set the fan mode (Normal, Up, Down).
y Lens Control
Use this function to set the lens control mode (Zoom/Focus).
y Lens Memory
Load Memory: Select this item to load the your own setting.
Save setting: You can adjust the OSD’s items by yourself then use this function to save your setting.
y Center Lens
Use this to center the lens.
y Warp
Use this to correct image distortion.
y Keystone
Press to correct horizontal keystone due to projection angle. Press to correct Vertical keystone due
to projection angle.
y Rotation
Press to correct incorrect image angle.
Press to adjust angle to correct.
Correct angle
Press to adjust angle to correct.
P
P
P
To Next Page
Loading...
