Vivitek D8800 - OSD Introduction - CONTROL

39
DLP Projector - User’s Manual
OSD Introduction - CONTROL
INPUTPICTURE
Eco Network Power
Auto Power Off
Auto Power On
Projector Control
Network
Start Up Logo
Trigger
Auto Search
Dynamic Black
Language
< Eco >
< On >
< Off >
< ----- >
Enter
< On >
< Auto >
< Off >
< On >
Enter
LAMPS ALIGNMENT CONTROL SERVICE
y Eco Network Power
Use   function to set Standard or Eco network power.
y Auto Power Off
The default value is OFF. If you set it to ON, the projector will automatically shut down after 20 minutes without
input signal.
y Auto Power On
The default value is Off. If you set it to ON, the projector will automatically start up when it is connected to AC
power. If you plug the projector’s power cord into an AC socket with a switch, you can use this function to start up
the projector using the socket’s switch instead of the remote. If you do not need this function, please set it to Off.
y Projector Control
Use   function to select RS232 or Network for the projector control.
y Network
Use this function to setup the network configuration.