OSD Introduction - SERVICE
INPUTPICTURE
Model :
Serial Number :
Software Version :
Active/PIP Source :
Pixel Clock :
Signal Format :
H/V Refresh Rate :
Lamp 1 Time :
Lamp 2 Time :
Power On Time :
Blue Only
Factory Reset
DP9675QDPxA
C202XXXX00767
MD05-GD02-Ub01- 9999-31-DPNE02-D02
HDMI / Off
83 .30 MHZ
1280x800@60Hz
H: 49.578 KHZ V: 60 HZ
7 HRS
7 HRS
7 HRS
< Off >
Enter
LAMPS ALIGNMENT CONTROL
SERVICE
The functions covered in this unit relate to the display of some basic information about the projector.
Note:
Memory of the custom timing files will be erased in the Factory Reset operation.
y Model
The designated model number of the projector.
y Serial Number
The designated serial number of the projector.
y Software Version
The version of software installed on the projector.
y Active/PIP Source
Displays the current Active/PIP sources.
y Pixel Clock
Displays the pixel clock of the current input signal.
y Signal Format
Displays the format of the current input signal.
y H/V Refresh Rate
Displays the horizontal and vertical refresh rates for the current image.
y Lamp 1 Time
Display the lamp 1 usage time. When you change the new lamp. The lamp hours will re-calculate the time.
To Next Page
Loading...
