40 Call Park
XTS-IP / XTSc-IP Station User Guide March 2007
Call Park - System
An external call can be placed into one of 14 parking locations and can
be retrieved by any station that has a direct line appearance or an
available Loop button. Parked calls have their own recall timer that
recalls the originating station, and if still unanswered, the Attendant(s).
To park a call, either:
1. Press the TRANS button. The caller will be put on hold.
2. Dial the parking location (424-437). A confirmation tone will sound.
3. If a busy tone is received, press TRANS twice and dial another park
location, or press the CALL PARK flexible button for a different
parking location.
-or-
1. Press the CALL PARK flexible button. The caller will be parked at the
location programmed on the button.
2. If a busy tone is received, press TRANS twice and dial another park
location, or press the CALL PARK flexible button for a different
parking location.
To retrieve a parked call, either:
1. Lift the handset or press the ON/OFF button (SPEAKER button on IP
Phone).
2. Press [#].
3. Dial parking location (424-437) where call was parked, or press the
preprogrammed PARKED CALL PICKUP flexible button.
-or-
Use the Soft Key’s P-PKP 1 option when in an idle condition (to
pickup from park location 1 only).
To create a PARKED CALL PICKUP button:
1. Press [SPEED] + [SPEED].
2. Press the desired flexible button.
3. Dial [#] + the desired parking location (424-437).
To Next Page
Loading...
Need help?
General
