18 Answering Machine Emulation
XTS-IP / XTSc-IP Station User Guide March 2007
89 (Loop Key) is changed to 8889
Answering Machine Emulation
When a call is sent to your voice mailbox, you can press a
preprogrammed flexible button to listen to the caller leaving the voice
mail message. If you decide to speak with the caller, you can press the
preprogrammed button to be connected to the caller.
Notification Methods
There are two methods of notification, a Ring Mode or a Speaker Mode.
These methods are controlled by the type of flexible button assigned
on the telephone.
The preprogrammed button type defines the operation mode
(654+0=Ring Mode, 654+1=Spkr Mode; 8665=Ring Mode - Alt Dial
Plan, 8666=Spkr Mode - Alt Dial Plan). An incoming CO call rings at
a station and forwards (except busy type) to station’s VM mailbox.
Ring Mode
The preprogrammed flexible button flashes red while the caller is in your
mailbox. You can press the flashing button and the audio is broadcast
over the speaker of the keyset. The MUTE key is also enabled and the
LED lights solid red. When the call is ringing the station in the ring
mode, the display shows:
The Alternate Dial Plan does not apply to MPB1 or MPB2
systems.
VM SCREENING RING
MMM DD YY HH:MM am
To Next Page
Loading...
