Run-in period for motocycle
Before driving the motorcycle, you need to read carefully the instruction for the service life and fuel
consumption greatly affected by the run-in period. （You will keep the vehicle’s performance and
attain fun with your right driving way in the first 1000 km miles).
Run-in period of the engine
·No matter the motorcycle is start or not, you need to keep enough time for the engine oil all over the
whole motorcycle before starting to drive.
·During the run-in period, the turning speed is not beyond the 5000r/min within 0-500km, and not
beyond 7000r/min within 500-1000 km.
·The gear and turning speed need to change frequently during the run-in period and forbid to work
continuously at one certain gear.
·The engine fixed on a low-speed(light load) will damage the motorcycle, thus producing a bad
cooperation between driver and vehicle, therefore, you should not drive at a constant speed with light
load.
·Except the emergency, avoiding the acceleration and brake during the run-in period.
You should keep the engine at its best work condition and do not driving with unmatched gear, ·
driving low-speed lows the gear in advance.
·Keep enough idle time for engine and avoid the long-driving during the run-in period.
34
To Next Page
Loading...
