he motorcycle is equipped with T engine oil-seal chain. Chain pin is wrapped by a special O-shaped sealing
ring filling grease. Special tools are required to replace such non-open locking chain. If necessary, please go
to the dealers authorized by VOGE for help.
heck or adjust the drive chain before driving every day.C
Check the following problems:
-Chain pin Loose -Roller breakdown -Chain plate corrosion
-inflexibility of chain link rotation
-Contact authorized dealer if there is any of the above problems.
Wear of the drive chain can also cause wear of the sprocket.
Aim at the following problems:
-Severe wear of sprocket -Broken of the tooth
-Contact authorized dealer if there is any of the above problems.
Maintenance of Drive Chain
Check the worn condition of the driven
and driving sprocket when replacing the
drive chain, and replace the sprocket
simultaneously if necessary.
· High-viscosity gear engine oil, SAE90,
can be used instead if there is no special
chain engine oil for engine oil seal chain.
· Clean the chain with water or neutral
detergent. Volatile solvents, such as
paint thinner, gasoline, etc. are
prohibited in cleaning the chain.
· High pressure cleaner is prohibited in
cleaning the chain.
!
Notice
Cleaning and lubrication
Dirt and dust on the chain will reduce the service life of the chain.
Please clean and lubricate regularly. Incorrect cleaning and
lubrication will damage the O-rings and grease, which will
accelerate the reduction of the service life of the chain.
· Wire brushes is prohibited in cleaning the chain.
· Wipe off water or neutral detergent immediately after cleaning,
and dry the chain for lubrication.
· Use chain oil for oil-sealed chain to evenly coat the inner and outer chain plates. After coating, wipe off
excess chain oil.
· Some chain lubricants contain solvents and additives that can damage the sealing ring. Please adopt
special oil seal chain lubricants.
!
Warning
59
To Next Page
Loading...
