EasyManua.ls Logo

VOGE 500AC E5 - Starting the Engine

VOGE 500AC E5
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The start of the engine
Stimulant exhaust from motorcycles contains carbon monoxide, a
colorless, odorless but highly toxic gas. To avoid the risk of poisoning,
you should not idle the engine for a long time in a poorly ventilated
place or in a room without ventilator equipment .
The colder the weather is, the longer the engine needs to warm up accordingly. Adequate preheating can
achieve better lubrication to reduce the engine wear and tear. Please do not idle the car for a long time,
because the poor heat dissipation easily causes engine overheating and damages to the internal parts.
In cold conditions, rotate the throttle properly while pressing the electric start button for easy start.
Engine lubrication works only when the engine is running. So don't let the engine shut down to drive the
motorcycle for a long distance. After the engine starts, please check whether the indicator light of the
instrument is always on or flashing abnormally. If so, please turn off the engine immediately and check
accordingly.
!
Notice
!
Danger
37
Lay down the side stand.
Check the choke switch of the engine on
this icon" "or not.
Insert the key into the ignition switch and
rotate it into this icon" ".
Check whether the engine is in the neutral position, if so, the neutral light of the meter ā€œNā€ will light up.
After meeting the following conditions, you should clench the clutch with your left hand to ensure safety and right
hand to press the electronic start button" ". No need to rotate the throttle handle at this time.
Release the electric start button immediately after engine ignition.
Start engine and allow engine to continue idling until fully warms up.
The interlock switch of ignition circuit and start circuit is designed in this car. The engine can only start under the
following conditions:
–When the gear is in its neutral position, the ignition switch and the choke switch start the position on " ". Hold
the clutch handle to ensure the safety.
– When the gear is in its non-neutral position ,the ignition switch and the choke switch start the position on " ".
Take back the stand side and clenching the clutch handle.

Table of Contents

Related product manuals