·Before disassembling and installing the battery, turn off
the ignition key.
·When removing the battery, remove the negative terminal
first, and then the positive terminal.
·When installing the battery, the positive terminal should
be installed first, and then the negative terminal.
·After each installation of the battery, turn on the ignition and wait for 1 minute before starting the
engine, so that the electronic equipment can be initialized.
Disassembly and assembly of battery
Do not turn the battery upside down as
this will cause the electrolyte inside to
come out of the vent.
External power
·When the battery power can not support the engine starting,
external power could be used.
· Starting with the help of external power , special spring clamp
with complete insulation at both ends shall be used to prevent short
circuit and fire jump caused by mutual contact of wires. Battery A is
the vehicle power and battery B is the external power.
The positive pole 1 of the external power B is connected to the
positive pole 2 of the vehicle power A, and the negative pole 3 of the
external power is connected to the metal body of the motorcycle for
grounding. If the engine fails to start, wait a few minutes for the next start to protect the engine and
battery. Allow the engine to run for a few minutes before removing the starting lead of the external
power, and disconnect the negative lead and ground wire first, then the positive lead.
!
Warning
48
To Next Page
Loading...
