Repair of tire
· To repair the tiny hole of tubeless tire, it is necessary to remove the tire and patch the inside of the
tire. External maintenance should be avoided as the centrifugal force will loosen the repaired place
when driving at high speed.
· The vehicle speed cannot exceed 80km/h 24 hours after tire repair.
· If the side is damaged, or the damaged place is more than 6mm, the tire cannot be repaired. Check
the tire. If considerably obvious depreciation exists on the tire, such as damage, scratch, or wear to
the limit, the tire must be replaced.
Replacement of Tire
· Ensure the vehicle adopts tires same in brand, models, patterns and use conditions when changing
tires. T he reinstalled wheels should be checked and adjusted for dynamic balance. The handling of
vehicle will be reduced and tire wear will be uneven with poor dynamic balance.
· The tire side is marked with an arrow to indicate rolling direction. The tires must run in this specified
direction to optimize driving performance in preventing water skiing, improving adhesion ability,
reducing driving noise, prolonging wear resistance and so on.
· The specified type of tire has been strictly tested and verified, and can meet the work requirements of
most roads. Adaptability or safety of untested tires cannot be guaranteed.
· Tubeless tires seal at the contact between rim and tire lip.
· To avoid air leakage, special tools and tire changer machines are required for disassembling and
installing tubeless tires. Attention should be paid to protecting tire pressure sensors when replacing
tires.
· Replacing tires should be handled by authorized dealers who have necessary tools and experience.
62
To Next Page
Loading...
