56
3 Intended use
The product is used to measure and display the power consump-
tion of electrical devices. The product is connected between the
mains socket and the electrical load and requires no additional
installation. Operation is only permissible when connected to an
earthed household mains socket. The max. admissible power rat-
ing of the connected load must not be exceeded (see chapter
“Technical data”).
Two different electricity tariffs can be entered for cost calculation
(e.g. for day/night-time electricity).
Furthermore, the CO
2
emissions of your electricity tariff can be
entered. The energy logger can then show how much CO
2
was
produced while the connected load was used (or how much CO
2
production was prevented when using electricity from sustainable
sourced compared to a normal electricity tariff).
The saved data can also be displayed when not connected to
a mains socket since in this case, the power is supplied by an
integrated Supercap capacitor.
The energy logger is not ofcially calibrated and therefore must
not be used for billing purposes.
It may only be used in dry indoor locations. The product must not
become damp or wet.
Read the operating instructions carefully and store them in a safe
place. Only make this product available to third parties together
with its operating instructions.
Observe all safety information and other information in these op-
erating instructions.
To Next Page
Loading...
Need help?
General
