81
9.9 Delete mode CLr
There are two functions to delete the stored data/settings.
It is recommended that you use them when a different load is con-
nected or a new measurement should be performed.
The CLr dAtA function enables you to delete/reset the following
parameters:
– Logging period
– Energy (kWh)
– Cost
– Operating time
– CO
2
emissions value
– Upper power and current limits
The CLr SET function enables you to delete the following param-
eters:
– Logging period
– Period setting
– Electricity tariff
To Next Page
Loading...
Need help?
General
