70
9.2 Entering, using and exiting the setup mode
Press and hold the button for 3 seconds to enter the
setup mode, and briey press the button to exit. Settings
will be applied after you close the menu.
Please note:
You can only access the setup mode when the energy log-
ger is in CURRENT mode.
When the display is not ashing, you can also leave the
setup mode by briey pressing the button. Your settings
will be saved.
When the display is not ashing in the setup mode, use the
button to toggle between the different settings.
You can use the following settings:
– Night mode
– Time and 12/24-hour mode
– Electricity tariff 1 and 2 (cost and start time)
– Standby and low standby limits
– CO
2
emission value for electricity tariff
– Overload alarm
– Delete mode
Briey press the button to modify the setting of the dis-
played function.
Briey Press the button to adjust the ashing value.
Briey pressing the button takes you to the next input
item or ends the input, depending on the setting.
To Next Page
Loading...
