62
This product should be used in an environment under the following conditions: This product should be used in an environment under the
following conditions:
– Altitude up to 2000m.Altitude up to 2000m;
Never touch the product or the mains plug with wet or damp
hands when trying to connect a plug to the front socket. This
may cause a fatal electric shock.
Never connect the product to the mains immediately after
it has been brought from a cold room into a warm one (e.g.
after being transported). The condensation that develops in
such cases could damage the device or cause an electric
shock! Let the product reach room temperature rst. Wait
until the condensation has evaporated; this may take several
hours. Only after this may the product be connected to the
mains supply and put into use.
Do not use the product if it is damaged. There is a risk of
fatal electric shock!
Switch off the mains socket to which the product is con-
nected (switch off at the corresponding circuit breaker or
remove the safety fuse, then switch off the residual current
operated circuit breaker). Then unplug the product from the
mains socket.
Switch off the mains socket to which the product is connected
(switch off at the corresponding circuit breaker or remove the
safety fuse, then switch off the residual current operated cir-
cuit breaker). Then unplug the product from the mains socket.
Discontinue use of the product and take it to a specialised
workshop or dispose of it in an environmentally friendly man-
ner.
To Next Page
Loading...
Need help?
General
