86
Setting the standby limit ensures the correct display of data for
operating conditions.
Use the button to switch the data displayed at the top of the
screen. You can see the following displays:
The power, current, voltage and power factor values are current
measurements.
The upper power and current limits are the maximum power and
current measurements since the last reset of the energy logger
(upper limits can be very short-term maximum values, e.g. during
the power-on).
<
<
<
or "W,A,V/PF, Hz/MAX A, MAX W, MAX V"
VAW PFHz Max V, Max A, Max W
To Next Page
Loading...
