Electronic devices are hazardous waste and do not belong in the household waste.
Dispose of the product at the end of its lifetime, according to the applicable legal regulations.
Remove batteries/rechargeable batteries that may be inserted and dispose of them separately.
The multimeter
does not work.
Is the battery dead? Check the status.
No measuring
change.
The HOLD function is activated
(display shows „H“)
Press the button „HOLD“ again.
The symbol „H“ disappears.
Is the wrong measuring function
active (AC/DC)?
Check the display (AC/DC) and
switch the function if applicable.
Did you use the wrong measuring
sockets?
Check the measuring sockets.
Is the fuse defect? In A/mA/µA range: Change the
fuse as described in the chapter
„Changing the fuse“.
Repairs other than those described should only be carried out by an authorised specialist.
If you have queries about handling the measuring device contact our technical support.
To Next Page
Loading...
