Voltmeter/Ammeter
Voltage values less than
20.0 V
are presented as LOW
if the engine speed is less than
800 rpm
for 10
minutes. Voltage values higher than
30.0 V
are
presented as HIGH.
J3008832
Fuel consumption
For setting the units, see section “Units”.
1 Average fuel consumption:
The value is presented as a figure and an arrow
pointing down, (e.g. ø26.) During a time after
resetting the display shows ”— — — ” while
average fuel consumption is calculated.
2 Instantaneous fuel consumption:
The value is presented numerically as well as in
the form of a bar.
J3014498
Note!
At idle, no bar is shown and the fuel
consumption is displayed in litre/hr
(alternatively gallons/hr).
Resetting, fuel consumption
To reset all fuel data, depress ”SELECT” for 1 second.
Leg data
The amount of fuel consumed since the last reset.
J3013617
Resetting, leg data
To reset all fuel data, depress ”SELECT” for 1 second.
90
Information display