• Faults are indicated by the LED flashing RED a
number of times. Each flash will last a ¼ of a
second
• After the number of flashes that indicate a fault,
there will be a delay with no flashes. The sequence
is repeated every fourth second.
• The LED always lights GREEN continuously when
the selected temperature has been reached. The
LED flashes GREEN while the compressor is
running in order to reach the selected temperature.
• If the LED flashes RED with a frequency that is
higher than 4 flashes per second and E1 or E2 are
displayed, then there is a fault in the NTC-sensor.
E3 Fault codes
Number of
flashes
Type of fault
1 The voltage guard has released
2 The condenser fan circuit is overloaded
3 The compressor does not start
4 Compressor speed is too low
5 The electronic unit's overheating protection
has released
Tips on saving energy
• Let warm goods cool down properly before you put
them in the refrigerator box
• Defrost as soon as you discover ice formation in the
refrigerator
• Do not keep the refrigerator/freezer space at too
low a temperature
• Do not open the door except when necessary
• Never leave the door open during normal operation
Fridge
371
To Next Page
Loading...
