Rocking to empty the platform
This method can be used to loosen loads that have got
stuck on the truck's platform.
1 Move the gear shift lever to the M position
2 Select gear 1
3 Choose driving program P
4 Accelerate and brake hard
5 Repeat in the opposite direction, if required
Driving on rollers
Sometimes the truck's drive shaft is used to drive e.g.
wheel washing equipment before driving on public
roads. Normally an up-change cannot take place while
the front wheels are still. To be able to change up in
these situations, do as follows:
1 Depress the accelerator pedal until the rear
wheels start to rotate
2 After 10 seconds, it is possible to change up to
the high range
E^ is shown in the display.
When driving on rollers it can be a problem to have
time to change gear without the rear wheels loosing
speed. Therefore, you can start even in a gear higher
than 6.
254
I-Shift
To Next Page
Loading...
