Raise the spare wheel
First check that the tensioning band
• is mounted
• is complete, including the seam
• has a knot in the roller
• is properly coiled on the roller
Tighten the band if necessary.
J0010181
If the vehicle has a side underrun guard or chassis
skirt, use the inner hole (A) on the holder.
Lay the wheel straight under the holder. Do not pull it
in with the winch.
Tighten all four nuts to
400 Nm
.
A crank for lifting up the wheel, and sleeve for
tightening the nuts are in the vehicle's tool equipment.
J0010183
External equipment
495
To Next Page
