The handset can be exchanged while the ignition is
ON or OFF.
It is strongly recommended you do not exchange the
handset while the vehicle is ON. You will be required
to conduct a breath test which may distract your
attention from the road.
In the interest of your own safety, you should only
exchange handsets when the vehicle is parked and the
ignition is OFF. To replace the handset while the
ignition is OFF, simply unplug the old handset and
plug in the new one, as described below.
1 Squeeze on both sides of the contact on the hand
unit's lower part to disconnect the hand unit from the
hand unit cable.
J138928
Warning!
Do not pull the hand unit cable.
The contact is similar to a RJ-45-
telephone connector and requires
you to squeeze lightly on the
release tags.
2 The LCD screen goes out when the cable is released
as shown in the figure to the left.
Alcolock
377
To Next Page
Loading...
