Getting started18 19
You can only put the cordless vacuum cleaner into
standby position when it is centred.
1. This is done by rotating the cordless vacuum
cleaner at the pivot so that both the cordless
vacuum cleaner and accessory head are facing
straight ahead
.
Now you can set it to standby position.
2. Move the handle forward until it is upright
and you hear it click into the pivot
.
If you put the cordless vacuum cleaner with
the electric brush into standby position without
having switched the cordless vacuum cleaner off
at the main switch, the cordless vacuum cleaner
will keep running and the electric brush will switch
itself off.
2.2.2 SETTING THE DEVICE INTO POWER
SETTING
In the power setting, the cordless vacuum cleaner
can be moved freely and the device can be steered in
all directions on the floor.
1. Hold the accessory head firmly in place with
your
foot
and tilt the handle back
so that
you hear the cordless vacuum cleaner disengage
from the standby position.
Now the accessory head can be moved in all direc-
tions again.
1
2
To Next Page
Loading...
Need help?
General
