Troubleshooting45
6.2 KOBOLD EBB100 ELECTRIC BRUSH
Fault Possible cause and rectification
The Kobold electric brush is too loud. The roller brushes may not be correctly inserted.
• Check whether the roller brushes are correctly in-
serted.
• Always replace both brushes together.
It may that original Kobold accessories were not used;
this can lead to bearing and motor damage.
• Use original Kobold roller brushes only.
An object may have become stuck in the area of the
roller brushes.
• Remove the object.
There may be loud noises when working on hard
floors.
• Switch to ‘normal’ brush mode.
The LED display on the cordless
vacuum cleaner lights up yellow.
The suction duct of the electric brush may be blocked.
• Open the inspection flap
on the underside of the
electric brush.
• Remove the blockage.
• If necessary, use an appropriate object to do this
(e.g. crochet needle).
• Put the inspection flap
back on.
To Next Page
