Vorwerk KOBOLD VB100 User Manual

Troubleshooting44 45
Fault Possible cause and solutions
The LED display lights up yellow
when the cordless vacuum cleaner
is on.
The premium filter bag may be full.
• Insert a new premium filter bag as described in
chapter “5.2.1 Replacing the Kobold FP100 Premium
Filter Bag” on page33.
The carpet may be too dense.
• Try vacuuming a different floor and check the LED
display again.
• Try vacuuming on a lower suction power level.
The suction channels may be blocked.
• Check and clean the suction channels.
The LED display on the cordless
vacuum cleaner flashes red.
• Contact your Vorwerk Customer Service Centre (see
chapter “9 Service” on page50).
The charging process takes too long
or the cordless vacuum cleaner does
not start after a short charge.
High temperatures can slow down the charging pro-
cess.
• Do not charge the device or the individual battery
pack (when removed from the cordless vacuum
cleaner) in the sun.
Charging may take longer after intensive use of the
cordless vacuum cleaner or at high temperatures. The
charging process can be accelerated by removing the
battery pack from the device and charging it directly
on the AC charger.
Transport mode cannot be switched
on.
Your cordless vacuum cleaner may already be con-
nected to the power supply and fully charged. If this is
the case, the LEDs will no longer be lit.
• Disconnect your cordless vacuum cleaner from the
power supply.
• Then proceed as described in chapter “3.6 Moving
the Kobold VB100 Cordless Vacuum Cleaner” on
page29.

Vorwerk KOBOLD VB100 Specifications

General

Brand	Vorwerk
Model	KOBOLD VB100
Category	Vacuum Cleaner
Language	English