Operation25
SETTING THE BRUSH MODE
The Kobold EBB100 Electric Brush starts up in
nor-
mal mode. You can set the operating mode using the
foot switch
on the electric brush.
1. Select the correct suction power level for your
floor according to the table on
page 26.
2. Press and release the foot switch to change
the brush mode.
The LEDs on the electric brush show which brush
mode you are in.
3. Press and hold the foot switch
for approxi-
mately 2 seconds to deactivate the brush.
The LEDs on the electric brush go out.
4. Press the foot switch
again to reactivate the
brush.
To find out more about the ‘Deactivate brush’
mode, see chapter “6 Troubleshooting” on
page43.
To Next Page
Loading...
Need help?
General
