Vox Tonelab EX - Adjusting Min;Max Values

30
4. Whenyou’vefinishedtuni
ng,pressoneoftheprogram
pedals1–4.
HINT: Youcanalsopress theEXIT/TUNEswitchtoreturnto
thepreviousoperation.
Switching tuning mode
Thebuilt‐inAutoChromaticTunerfeaturesswitchableNor‐
malandStrobemodes.Toswitchtuningmode
,pressthe
EXPRESSIONswitchduringtuneroperation.
Whenthemodeisswitched,theBank/Valuedisplayindicates
“ ” (normal)or “ ” (strobe)foronesecond.
NOTE: This mode setting will be saved when you turn the
poweroff.
Normal mode
Tunethestringsothatonlythemiddleindicator(outofseven
tunerLEDs)lightsupgreen.
Ifthetuningissharp,anLEDontherightsidewillbelit.
Ifthetuningisflat,anLEDontheleftsidewillbelit.
Strobe mode
TunethestringsothatmovementofthetunerLEDillumina‐
tionstops.
Ifthetuningissharp,illuminat
ionoftheLEDswillstartwith
theLEDontheleftendandmovetowardsright.
Ifthetuningissharp,illuminationoftheLEDswillstartwith
theLEDontherightendandmovetowardsleft.
Whenthestringisintune,themovementofillu
minationwill
stop.
Calibrating the tuner
Calibrationspecifiesthereferencepitchfortuning(expressed
asthefrequencyofthemiddle‘A’ noteonapiano).Youcan
adjustthisinarangeof438Hz–445Hz.
NOTE: The calibration setting you specify here will be dis‐
cardedwhenyouturnof fthepo wer.Whenyouturn
thepoweronagain,itwill automaticallybesetto440
Hz.
1. Activatethetunerasdes
cribedinstep1of“T
uningpro‐
cedure”(p.29).
2. While holding down the EXIT/TUNE switch, us
e the
BANKUP/DOWNpedalstoadjustthereferencepitch.
Thebank/valuedisplaywillindi
cate“38”–“45 ” (438Hz–
445Hz).Specifythedesiredreferencepitch.
3. Release the EXIT/TUNE switchto complete the calibr
a‐
tionsetting.