Vox Tonelab EX - Connecting and Powering On; Trying out the ToneLab EX; Performance Modes Overview

10
2. Use a cable to connect the To
neLab EX’s OUTPUT/
PHONESjacktoyourguitaramp,mixer,orotherdevice.
NOTE: Before connecting the ToneLab EX, lower the vol‐
umelevelofyourguitarampormixer.
TheOUTPUT/PHONESisequippedwithast ereo output
jack.Useastereo(TRS)cableto enjoylisteningtoorre‐
cordingwithyourToneLabEXinstereo.
Ifyouramplifierormixerhasonlymonoinputs,youcan
purchaseacablethathasastereoplugononeend,and
twomonoplugs(LeftandRight)ontheother.
ConnectingamonocabletotheOUTPUT/PHONESja
ck
willonlypickupthesoundfromLeftchannel.
3.
Set the LEVEL knob and SPEAKER LEVEL knob on the
rearpanelto“0”byturningtheknoballthewaytotheleft
(asseenfromtherearpanel).
4. ConnecttheplugendoftheACadapter
(included)totheDC12Vjackontherear
paneloftheToneLabEX,andtheother
endintoanACoutlet.
SecuretheACadaptercablearoundthe
cablehook;thiswillreducestressonthe 
plugend of theadapter,andpreventit
fromdisconnectingaccidently.
5. Us
ingastandardguitarcable,connect
yourguitartothe
INPUTjackoftheToneLabEX
6. Make sure that the volume of your amp or mixer is
turneddo
wn,andthensettheON/STANDBYswitchon
theToneLabEXtothe“ON”position.
7. Raisethevolumecontrolsofyourampormixertotheir
normallevels,andus
etheLEVELknobor 
SPEAKER
LEVELknob ontherearpan eltoadjustthevolumetoa
suitablelevel.
NOTE: TheToneLabEXusesavacuumtube,soitmaytake
afewsecondsforthevacuumtubetowarmup,and
fortheToneLabEXtoproducesound.
Trying out the ToneLab EX
TheToneLabEXhasatotaloftwohundredprograms,con‐
sistingofrewritableuserprogr
ams(Banks 1–25x4)andpre‐
setprograms(Banks26–50x4).
Performance modes
TheToneLabEXfeaturestwoperformancemodes:Program
Selectmodeenablesyoutoselectandplayprograms;Stomp
Boxmodeenablesyo utoturnonoroffindividualeffects
assignedintheselectedprogram.
Switching between modes
PressboththeBANKUPandBANKDO
WNpedalssimulta‐
neouslyforonesecond.
Repeatthisoperationtotogglebetw
eenStompBoxmodeand
ProgramSelectmode.
IftheBank/Valuedisplayind
icatesabanknumber,Program
Selectmodeisengaged.Ifthedisplayindicates“ ,”Stomp
Boxmodeisengaged.