Vox Tonelab EX - Computer Connectivity (USB); Librarian Software Usage; Audio Data Transfer

32
To assign volume, gain, or the input level to the reverb or
delay effect, procee
d as follows.
• Vo
lume : UsetheVOLUMEknob,andthenholddownth
e
EXPRESSIONswitchforabout twoseconds .
• Gain:
Press the AMPS bank select switch or STAND ALONE
PEDALSswitch,usetheGAINknob,andthenholddownthe
EXPRESSIONswitchforabouttwoseconds.
• Pedal1: Usethe PEDAL 1 knob, and then hold down the
EXPRESSIONswitchforabouttwoseconds.
• Input level to the reverb effect: Use the REVERB knob,
andthe nholddowntheEXPRESSIONswitchforabout
twoseconds.
• Inputleveltothedelayeffect:UsetheDELAYknob,and
thenholddowntheEXPRESSIONswitchforabouttwo
seconds.
To clear the expression pedal to an unassigned state
HolddowntheEXPRESSIONswitchandpresstheEXIT/
TUNEswitch.Theexpressionpedalassignment willbe
cleared,andtheEXPRESSIONPEDALLEDwillgodark.
Theexpressionpedalwillalsoreverttoanunassi
gnedstateif
youswitchtoadifferenteffect.
Howeverinthefollow ingcases,the
settingwillbemain‐
tainedandtheassignmentwillnotchange.
•AftertheGAINparameteroftheampmodelorstandalone
pedal typewas  assigned to theexpressionpedal,you 
changedtheampmodelorstandalonepedaltype.
Expression pedal minimum and
maximum values
Theminimumvalueiswhentheexpressionpedalisfully
returnedto wardyourself;themaximumvalueis whenthe 
expressionpedalisfullyadvancedawayfromyourself.
Whenyou assigna parameterorvolu
me totheexpression
pedal,theminimumandmaximum valuesoftheexpression
pedalwillbesetautomatically.
Adjusting the minimum and maximum parameter values
Whenyouassignaneffectparametertotheexpressionpedal,
theminimumandmaximumval ue sappropriateforthat
parameterwillbeassignedastheminimumandmax imum
va l ues  of th eexpression pedal. Ifyou assignthePITCH
parameterofthePITCH,theminimumvaluewillbe“0”(no
pitchshift)andthemaximumvaluewillbethecu
rrentvalue.
Youcanadjusttheminimumandm
aximumvaluesasfol‐
lows.
NOTE: Ifthereverb,delayeffectinputlevelisassignedtothe
expressionpedal,theminimumandmaximumvalues
willbesetautomatically,andcannotbechanged.
1. PresstheEX
PRESSIONswitch.
TheQuickAs
signLEDwillblink.
If an effect is assigned to the expression pedal
Theon/offswitchLEDoftheassignedeffectwillblink,
andthebank/valuedisplaywillindicate“ ”.