Vox Tonelab EX - Factory Settings Restoration; Resetting to Default Programs; Troubleshooting; Power and Sound Issues

33
If no function is assigned to the expression pedal
Thebank/valuedisplaywillblink“ ”.Inthiscase,use
QuickAssigntoassignafunction(p.31,“Assigninga
functiontotheexpressionpedal(QuickAssign)”).
2. UsetheED
ITknoboftheassignedeffect(whoseon/o
ff
switchLEDisblinking),ortheGAINcontroltospecify
theminimumvalue.
HINT: Youcanskipthisstep,ifyoudonotchangethemini‐
mumvalue.
3. PresstheEXPRESSIONswitch.
Thebank/valuedisplaywillindi
cate“ ”.
4. UsetheEDITknobyouus
edinstep2,ortheGAINcon‐
troltospecifythemaximumvalue.
HINT: Youcanskipthisstep,ifyoudonotchangethemaxi‐
mumvalue.
NOTE: Ifyoudecideto cancel thesetting,presstheEXIT/
TUNEswitch.
5. PresstheEXPRESSIONswitch.
Thebank/valuedis
playwillindi
cate“ ”foraboutone
second.
TheQuickAssignLEDwillgodark.
NOTE: Theassignmentofafunctiontotheexpressionped‐
al,the minimumvalue,and themax
imumvalue
arespecifiedindependentlyforeachprogram.
6. Ifdesired,savethesesettingstotheprogram.
Ford
etailsontheprocedure,referto“Savingaprogr
am”
(p.15).
NOTE: Thesettingsyoumadewillreturntotheiroriginal
valuesifyouswitchprogramsorturnoffthepower
beforesaving.
Adjusting the minimum and maximum volume
Ifvolumeisassignedtotheexpressionpedal,youcanadjust
theminimumandmaximumvaluesasfollows.
1. PresstheEXPRESSIONswitch.
TheEXPRESSIONPEDAL
LEDandQuickAssignLED
willblink,andthebank/valuedisplaywillindicate“
”.
2. UsetheVOLUMEcontroloftheAMPsectiontospeci
fy
theminimumvalue,andthen presstheEXPRESSION
switch.
Theminimumvaluewillbespeci f
ied,andthebank/value
displaywillindicate“ ”.
3. UsetheVOLUMEcon
troltospecifythemaximumvalue,
andthenpresstheEXPRESSIONswitch.
Thebank/valuedisplaywillindicate“ ”foraboutone
second.