44
PHONE SETTINGS
7.6 Registration
Your handset and base station is pre-registered. Up to ve handsets can be registered
to a single base station.
If for some reason, the handset is not registered to the base station ( ashes even
when the handset is near the base station), register your handset according to the
following procedure.
On the cordless handset:
Press and / to select REGISTER.
If you have more than one base, press and / to select the base
number from BASE 1, 2, 3 and 4. There will be a behind the current registered
base number.
Press to display “PIN?”, enter the 4-digit system PIN for the base (default
PIN is 0000).
Press and the display will show “SEARCHING”.
At the same time, press and / on the base to select REGISTRATION.
Press to see “PLEASE WAIT” ashing on the base display. After a short
delay, if the registration is successful, there will be a conrmation beep, and the
handset display will go back to idle mode with the new handset number shown.
The base display will also go back to idle mode.
Press at any time to cancel.
1.
2.
3.
4.
5.
6.
7.
To Next Page
Need help?
General
