17
USE YOUR PHONE
4.9 Find the Handset
You can locate the handset by pressing on the base. All the handsets registered
to the base will produce the paging tone and “PAGING” is ashing on the screen. You
can stop the paging by pressing / / on any handset or on the base again.
NOTE
If there is an incoming call during paging, paging will cease and the phone will ring with
the incoming call instead.
4.10 Make an Internal Call
This feature is only applicable when there are at least two registered handsets. It
allows you to make internal calls, transfer external calls from one handset to another
handset and make conference calls. If the called handset is not answered within 60
seconds, the called handset will stop ringing and the calling handset will return to
standby mode.
NOTE:
If only one handset is registered to the base station, press will display “NOT
POSSIBLE”.
4.10.1 Call Another Handset
In idle mode, press and the available handsets will display except the calling
handset.
Enter the desired handset number with which to connect via intercom.
When the called handset rings, press or on the called handset to establish
the internal call.
NOTE
If there are only two handsets are registered to the base station, press on one
handset will connect to the other handset immediately.
4.10.2 Call All Handsets
In idle mode, press and all registered handsets will display.
Press to ring to all registered handsets.
The rst handset to answer will intercom with the calling handset.
1.
2.
3.
1.
2.
3.
To Next Page
Loading...
Need help?
General
