VTI Instruments EX1200 Series - Removing IO Matrix Cards from SMP-4 Module

VTI Instruments Corp.
162 EX1200-7100 Plug-in Module
Removing IO Matrix cards from SMP-4 Module and EX1268A Chassis
F
IGURE
4-82:
REMOVING
IO
CARDS FROM
SMP-4
MODULE
D
IAGRAM
Procedure: Remove Handle assemblies at top and bottom by unscrewing 8 no’s of screws as shown above.
F
IGURE
4-83:
REMOVE
IO CARDS
FROM
SMP-4
MODULE
D
IAGRAM
Procedure: Align the Handle with 2 no’s of captive screws with two no’s of standoff’s on D-Sub connector on each Line
card and drive the two captive screws completely to hold handle with the line card for pulling the cards assembly out from
the module as shown above.