Wacker Neuson EZ26 - Hydraulic Connections

5-40 BA EZ26 en/us* 1.0 * EZ26_01_510.fm
5 Operation
Connecting and disconnecting hydraulic couplings
1. Park the vehicle – see chapter “ Preparing lubrication” on page 7-9.
2. Turn the starting key to position 1.
3. Release the pressure of the work hydraulics – see chapter “ Release
the pressure of the work hydraulics” on page 5-39
4. Remove the starting key and carry it with you.
➥ The couplings of the attachment can now be coupled and uncoupled.
Hydraulic connections
Information
Follow the instructions in the Operator’s Manual of the attachment
manufacturer for connecting the hydraulics to the attachment.
Proceed as follows after a damage:
1. Stop the vehicle immediately.
2. Stop the engine
3. Move the control lever or stabilizer blade lever to neutral.
4. Perform emergency lowering if possible – see chapter “5.13
Emergency lowering” on page 5-57
5. Raise the control lever base.
6. Remove the starting key and lock the cabin.
7. Secure the vehicle and the attachment.
8. Contact a Wacker Neuson service center and have the malfunction
rectified.
Environment
Use a suitable container to collect fluids and lubricants as they flow out
and dispose of them in an environmentally friendly manner.
Fig. 178:
A B C
Connection Stick (left/right)
A AUX V
B AUX II/AUX III
C AUX I
D Hammer return line
Fig. 179:
D C
AB