4-32 BA EZ26 en/us* 1.0 * EZ26_01_400.fm
4 Putting into operation
Requirements and information for the operating personnel
Read, understand and follow this Operator’s Manual and all other
Operator’s Manuals supplied with the vehicle.
The vehicle may only be put into operation by authorized personnel that
has been instructed – see chapter “2.3 Conduct” on page 2-3.
The operator must know and adhere to the requirements and risks at the
workplace.
Perform daily maintenance according to the Lubrication and maintenance
plan (see chapter “Maintenance 7.2”)
Face the vehicle as you enter and exit it, and only use the mandatory
climbing aids for entering and exiting.
Keep the footholds and the handholds clean to ensure a safe hold at all
times. Immediately remove dirt, oil, snow, etc.
Do not get on a moving vehicle, or jump off it.
Do not operate the vehicle if the standard protective equipment (for
example the cabin) has been removed.
No clothes or parts of the body may protrude outside the vehicle during
operation.
Check lists
The checklists below assist you in checking and monitoring the vehicle
before, during, and after operation.
Wacker Neuson does not claim those lists to be exhaustive.
If the answer to one of the questions is No, first rectify the cause of the
fault (or have it rectified) before starting work.
The checking and monitoring work listed below is described in greater
detail in the following chapters.
To Next Page
Loading...
