wc_tx003819gb_FM10.fm
102
General Maintenance RT / RTx
7.11 Maintaining the Fuel Filter Water Separator—Kubota Engine Only
Requirements
■ Engine is stopped
■ Suitable container to collect drained fuel/water
■ New filter
Draining the
bowl
Perform the procedure below to drain the fuel filter water separator.
1. Locate the drain valve (a) on the fuel filter water separator.
2. Place a suitable collection container beneath the drain valve.
3. Open the drain valve by turning it counterclockwise. This will drain the fuel/
water.
4. Close the drain valve when draining is complete.
Note: Dispose of drained fuel/water in accordance with the local environmental
protection regulations.
Changing the
filter
Perform the procedure below to change the filter.
1. Pull the filter (b) and bowl (c) (as an assembly) off the housing (d).
2. Unscrew the bowl from the filter. Discard the filter.
3. Install a new filter onto the housing.
4. Re-install the bowl.
To Next Page
Loading...
