EasyManuals Logo
Home>Wacker Neuson>Construction Equipment>RTx-SC3

Wacker Neuson RTx-SC3 User Manual

Wacker Neuson RTx-SC3
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #143 background imageLoading...
Page #143 background image
Operate Safely
29
Towed Rollers
Most general safety precautions covered earlier in this
manual are also applicable to towed roller operation.
There are many precautions speci c to towed rollers
that must be taken. Study your manufacturer’s manual
for instructions on your speci c towed roller. Consult the
manufacturer or dealer with any concerns.
Use a tow tractor of suf cient weight, drawbar
horsepower and braking capacity to properly control the
towed roller. Proper weight balance and distribution is
also essential.
Block under the tongues of the towed roller before
attempting to connect it to the towing vehicles or
machine. Do not attempt to lift heavy tongues or move
towed rollers by hand. Do not get any part of your body
under the tongues when hitching or unhitching.
Make sure the hitch pin is of the proper size, and is
securely locked in place before towing. If safety chains
are provided, make sure they are properly and securely
connected at both ends. Cross the chains under the
tongues when connecting to the towing vehicle. Make
sure all electrical or hydraulic connections are made
properly and securely.
Land ll Compactors
Operators of land ll compactors should carefully handle
materials that could be picked up and thrown by the
wheels, become lodged in the machine, or that are
highly  ammable.
Frequent checks should be made for wire, cable
or other material wound around the axle members.
Remove them immediately.
Travel with the blade as low as possible.
Maintain good operator visibility. Keep all mesh and
windows free of accumulated materials.
When parking the machine, always lower the blade.
30
Shut Down Safely
Select a Proper Parking Site
Park in an off the road area, out of traf c, or as
instructed. If necessary to park in a traf c lane, use the
appropriate  ags, barriers,  ares, lights and warning
signals. Provide advance warning signals in the traf c
lane to warn approaching traf c.
Park on level ground whenever possible. When that’s
not possible, position the machine at right angles to
the slope. Make sure the machine is on a  rm footing,
and that there is no danger of sliding. Do not leave your
machine until you are sure it is safely blocked in both
directions and parking brakes are  rmly applied.
WARNING! Avoid death or serious injury. Never
leave the compactor unattended with the engine
running.
Safe Shutdown
Know the proper shutdown procedure for your machine.
As with the starting procedure, this varies with the type
and model of machine.
If equipped, always lower the dozer blade when parking.
Follow the manufacturer’s operation manual for your
machine. Remove the key(s) to prevent unauthorized
starting and movement, and position and lock any
antivandalism devices.
Dismount Properly
Make sure your machine is fully stopped and shut off
before dismounting. When you leave the compactor,
always maintain three-point contact with the steps and
grab handles. Face the compactor as you dismount.
Never jump off a machine.
Shut engine off,
remove key
Use three points
of contact when
mounting or
dismounting

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson RTx-SC3 and is the answer not in the manual?

Wacker Neuson RTx-SC3 Specifications

General IconGeneral
BrandWacker Neuson
ModelRTx-SC3
CategoryConstruction Equipment
LanguageEnglish

Related product manuals