wc_tx003863gb_FM10.fm
65
RT / RTx Operation
4.23 Before Starting
Before starting the machine, check the following items:
■ Read safety instructions at the beginning of this manual
■ Check fuel level
■ Check engine oil level
■ Check hydraulic fluid level
■ Check fuel lines
■ Check air cleaner
■ Check water level
■ Make sure scraper bars are clean and properly adjusted
■ Clean the transmitter and receiving eyes
■ Check that the articulated joint locking bar is in the storage position
■ Check that the SmartControl
TM
transmitter module and the machine’s decoder
module are set to the same control channel
Note: All fluid levels should be checked with the machine on a level surface.
To Next Page