wc_tx003819gb_FM10.fm
92
General Maintenance RT / RTx
7 General Maintenance
7.1 Periodic Maintenance Schedule
The table below lists basic machine maintenance. Tasks designated with check
marks
may be performed by the operator. Tasks designated with square bullet
points require special training and equipment.
1
Change after the first 100 hours of operation.
Roller
Daily
before
starting
Every
100
hours
Every
500
hours
or 1 year
Every
1000
hours
or 2 years
Check for loose or missing fasteners.
Replace as needed.
Check hydraulic oil. Fill to correct level.
Clean control box / transmitter.
Verify that receiving eyes blink rapidly when
approached by the operator.
Grease articulated joint.
Grease steering cylinder.
Change hydraulic system return line filter.
1
Change hydraulic fluid.
To Next Page
Loading...
Need help?
General
