wc_tx003818gb_FM10.fm
83
RT / RTx Engine Control Module (ECM) Diagnostics
Code Description
E00 Possible bad glow time sensor
E01 Possible bad temperature sensor
E02 Possible bad air flow sensor
E03 Possible bad oil pressure sensor
E04 Possible bad tip sensor
E05 Temperature sensor was unplugged
E06 Air restriction sensor was unplugged
E07 Oil pressure sensor was unplugged
E08 Open starter solenoid
E09 Open fuel solenoid (Kohler powered machines only)
Open stop solenoid (Kubota powered machines only)
E10 Open throttle hold solenoid
E11 Open throttle pull relay
E12 Open glow plug relay
E13 Open RX power relay
E14 Open LED ring output
E15 Low battery
E16 Starter solenoid
E17 Shorted fuel solenoid (Kohler powered machines only)
Shorted stop solenoid (Kubota powered machines only)
E18 Shorted throttle hold solenoid
E19 Shorted throttle pull relay
E20 Shorted glow plug relay coil
E21 Shorted RX power relay coil
E22 Shorted LED ring output
E23 High oil pressure on power up
E24 Starter solenoid over current
E25 Fuel solenoid over current (Kohler powered machines only)
Over-current stop solenoid (Kubota powered machines only)
E26 Throttle hold solenoid over current
E27 Throttle pull relay coil over current
E28 Glow plug relay coil over current
E29 RX power relay coil over current
E30 LED ring output over current
E31 Open
E32 High starter solenoid current
E33 High fuel solenoid current (Kohler powered machines only)
High stop solenoid current (Kubota powered machines only)
E34 High throttle hold solenoid current
E35 High throttle pull relay coil current
To Next Page
Loading...
Need help?
General
