20 Analog mode 76
20.1 Analog calibration 77
20.2 Calibrate Input 1 78
20.3 Setting a high signal 79
20.4 Setting high flow calibration 80
20.5 Setting a low signal 81
20.6 Setting low flow calibration 82
21 MemoDose mode 84
21.1 To configure MemoDose 84
21.2 Set flow rate 84
21.3 Resume interrupted doses 85
21.4 Master dose 86
21.5 Manual dosing 89
22 EtherNet/IP™ mode 90
22.1 Configure EtherNet/IP™ Settings 90
22.2 EtherNet/IP™mode 94
22.3 Example for http connection between pump and PC (peer-to-peer) 94
22.4 Setting up the PC 95
22.5 Connecting the PC to the pump 96
22.6 Connecting using the web browser 97
22.7 Connecting to a PLC 97
22.8 Pump parameters 101
23 Sensors 113
23.1 Sensor wiring 113
23.2 Setting up the sensors 114
23.3 Start up delay 118
23.4 Generic Sensors 120
23.5 Flow Sensor Reading 126
24 Main menu 127
24.1 Security settings 129
24.2 General settings 140
24.3 Control settings 150
24.4 Configure outputs 153
m-630un-en-08 3
To Next Page
Loading...
