Wavetek STABILOCK 4031 - Handoff Procedures; Change Analog;Digital Traffic Channel

Handoff Procedures
You use the handoff procedures to test whether the mobile – during a call –
correctly adopts changes in transmission parameters (channel, SAT, power level,
time slot, etc) as instructed by the base station (ie the test setup).
☞
Do not forget to confirm every change in an entry field of the basic mask with
[ENTER]
.
Change analog/digital traffic channel
WHY?

Test whether the mobile correctly changes to another
analog/digital TC. All variants are permissible, eg also
changing from an analog to a digital TC and from
800 MHz DTC to 1900 MHz DTC (and vice versa).

Test whether the frequency error and transmitting power
of the mobile in the target channel meets requirements.
Requirement

The mobile is not in test mode.

Make the general test preparations.

Initiate a call with
{MOBILE}
or
{CELL.}
(the mobile must be
in an analog or digital traffic channel).
IS-136 MS Handoff Procedures
10-20