EN
5110326C_OI-II_Webasto Live 33
2.3 Safety information for
installation
– Installation and connection of the
charging station must only be carried
out by an electrician.
– Only use the supplied installation ma-
terial.
– The Webasto Live safety concept is
based on a power supply system that
is earthed at all times. The electrician
must ensure this requirement during
installation.
– Do not install the charging station in
an explosion sensitive area (EX zone).
– Install the charging station in such a
way that the charging cable does not
block any passageways.
– Do not install the charging station in
areas subject to ammonia or air con-
taining ammonia.
– Do not install the charging station in
a location where falling objects (e.g.
extension reel or tyres) can damage
the charging station.
– The charging station is suitable for
use indoors as well as outdoors.
– Do not install the charging station in
the vicinity of water jets, e.g. car
wash installations, high pressure
cleaners or garden hoses.
– Protect the charging station against
damage caused by sub-zero temper-
atures, hail or similar.
– The charging station is suitable for
use in areas without access restric-
tions.
– Protect the charging station from dir-
ect sunlight. The charging current
may be reduced at high temperatures
or charging may be disabled com-
pletely.
– The installation location of the char-
ging station should be selected such
that vehicles cannot inadvertently col-
lide with it. Protective measures must
be implemented if the possibility of
damage cannot be ruled out.
– Do not place the charging station into
operation if it is damaged during in-
stallation. A replacement will be re-
quired.
2.4 Safety information for
electrical connection
– Comply with the locally applicable re-
quirements pertaining to electrical in-
stallations, fire protection, safety reg-
ulations and escape routes at the in-
tended installation location.
– Each charging station must be protec-
ted with its own line circuit breaker
and residual current circuit breaker.
See "Criteria for the electrical connec-
tion on page 36".
– Make sure that the electrical connec-
tions are de-energised before con-
necting the charging station to the
power supply.
– Make sure that the correct supply
cable is used for the power connec-
tion.
– Do not leave the charging station un-
attended with the cover open.
– Register with the power supply com-
pany as required.
2.5 Safety information for
initial start-up
– Initial start-up of the charging station
must be carried out only by an electri-
cian.
To Next Page
Loading...
Need help?
General
