EN
5110326C_OI-II_Webasto Live 47
Local conditions:
The charging station should not be exposed
to direct rain or sunlight in order to prevent
damage.
The location of the charging station should
be selected such that vehicles cannot inad-
vertently collide with it.
The legal requirements for electrical installa-
tions, fire protection, safety regulations and
escape routes have been met.
The charging cable does not block any pas-
sageways.
The charging cable and coupling has been
protected against coming into contact with
external heat sources, water, dirt and chem-
icals.
The charging cable and coupling has been
protected against being driven over, trapped
or any other mechanical hazards.
The customer/user was informed how the
Webasto Live voltage is switched off with
the installation-side protective devices.
Charging station requirements:
The cable support sleeves for the power
cable and data cable (for live only) have been
fitted during installation.
The kink protection for the charging cable
has been screwed onto the charging station
and the rubber seal has been fitted correctly
into the kink protection.
Charging station requirements:
The suitable charging cable (11 kW or 22
kW) has been installed in the charging sta-
tion (as per type label) during installation.
The strain relief clamp that ensures the char-
ging cable has strain relief has been fitted.
The specified torques have been observed.
The charging cable has been connected as
per the instructions in the operating instruc-
tions.
Tools and installation remnants have been
removed from the charging station before
closing the cover.
The serial number of the charging station
has been registered on the online portal:
https://webasto-charging.com
Customer/client:
Place: Signature:
Date:
Electrician/contractor:
Place: Signature:
Date:
To Next Page
Loading...
Need help?
General
